Recent content by Grzes

START LOOKING IN THE OPERATOR'S MANUAL... It usually explains which fuse protects which element. Rule #2 on this forum: listen to other's advice; you'll be pointed in the right direction. If you can't figure out things like that, then you should probably bring the machine to the service center...

My 4610 operator's manual tells to use "1 gallon of fresh 10W40 oil for each chain case", but don't overthink it too much. It is a chain case, so any engine or gear oil will work. Antfarmer has a point: try to use something heavier since the oil seals are most likely worn, and they are going to...

Please, share if you can. My email: [email protected]. I still use my 4610, but keep my eyes open on something heavier. Definitely Gehl. These machines are the best!

I get the same symptoms on my 4610, but I would suspect the cooling system on my machine. The hydraulic system seems to be unaffected (all cylinders and drive pumps work perfectly fine without any interruptions), hence most likely the head gasket is asking for some attention. Otherwise I can't...

Would you be willing to share this manual? I currently own 4610 but planning to upgrade to something newer and slightly heavier. You never know. Maybe I'll end up buying 4840.

Any of the above should work, especially on older machines. However, keep in mind that fluids for hydraulic systems are designed specifically for that purpose. They don't tend to foam up create bubbles), as oppose to engine oil, which may turn into a foam bath coming out of the hydr. fluid tank...

This is a tough call. Sometimes getting a user or part manual for older models is difficult if not impossible, not to mention parts. As far as changing from spline to keyway, it might work, but I wouldn't expect it to last as long as the spline would. In general, the spline system (even though...

Gehl 4510, would you be able to sketch a schematic how the aux hydr. are installed? This would help me a lot instead of sitting and trying to figure out the system? Any photos would be greatly appreciated. Thanks

My 4610 Operator's Manual says 16GPM which would be about 1liter/s (metric equivalent). I believe it is the same for 4510 since the manual was written for both models. Please, let me know when you figure everything out. I am planning to add aux hydraulics to my machine (mainly for using a log...

Try FRAM website. If you cannot find your exact model number (your machine model), they have a catalogue with other manufacturers' filters and you can determine the type of filters from there using competitors' filter numbers. Also go to for example ebay and type in an engine model of your...

4610 Operator's Manual tells you to use 10W40, but personally I think you can use any gear or engine oil. After all, it is only a chain drive, it doesn't operate under extreme conditions. Components like an engine or hydraulic system require a little more caution when changing oil, since they...

I was using for a while a Bobcat 743 (borrowed) with hand/foot controls. Recently I purchased my own Gehl 4610, where left hand controls driving, and right operates the bucket and arms. It was a little awkward in the beginning, but after a few hours I got used to this set up. If you are planning...