foton's latest activity

well I like to use conventional and just change it sooner than required, I do mine like at every 250 hrs. and being in ohio it does get...

I would take the starter back off and get a flashlight or a inspection camera and look at the teeth on the ring gear, did you compare...

this is just a guess but I would think that the electrically triggered injectors operate at such high pressures that the overfuel spill...

I would think in hot climates straight 30 would be ok most anywhere else either 10/30 or 10/40 should be fine.

could it be possible that the fuel tank is not vented, causing it to cause a vacuum and not letting the pump pull fuel?

which might not be as a big of a deal if the blocks deck needs to be trued anyway. but that call is yours either method is ok.

for some reason this section it not translating your post ,and I do not know italian,so I will guess that the picture is asking if this...

you can open them all slightly ,and most likely they will prime at a litttle different times . just make sure you do not get sprayed...

well when you get into these chinese made equipment ,you have to be willing to do all the wrenching on it and parts scrounging as...

time for rings, bearings , use a macinists straight edge and check the block for flatness . If the head was warped the block I would...

messy is right ,more so if the tank is near full ,I would pump out what I can and then if you want to fully drain it out then go after...

once you verify that it is overheating , it could be a faulty thermostat, if it is not overheating it could be a faulty temp. sensor...

I think a filter change would do it.

I ahve used a drill powered pump with good luck , adding some sort of weight to the suction hose to keep it from curling and on the...

if all else fails ,take the sending unit out and take it to like napa and see if someone there identify it as one they can get. you...