FJRDarksider's latest activity

I picked mine up on Amazon for $160 at the time (1993 853)......it's listed as $199 now. Been working great for the last 50+ hours of...

All I can tell you is those seals were about 1-2mm larger in inside diameter to the spools in my control valve. The "Long Chamfer" was...

I don't disagree, but it appears there were a couple of different control valves for those model years. The SM I have on hand lists a...

I took apart the spool and put it back together and took the advice of the service manual and used loctite to hold that center screw at...

That's strange for sure. The cap shouldn't misalign as the end goes through the top of the cap with the detent sleeve. It certainly...

Just did mine on my 853. You may have tried this but try rotating the housing 180 degrees. It makes no difference to the action of the...

j

That would be my guess, or clogged. However, if you are getting diesel to the injectors after cracking them, perhaps an injector issue...

I believe all Bobcats, and other skid steers for that matter, are self purging on startup. When I change oil, I fill the hydraulic tank...

Agreed on the cost of hoses. I took what I needed to replace over to Princess Auto (Ontario) and they custom cut it to match the...

I have 4 brand new spool seals. Part # 6683274 I had bought them for my 853 but they were too large. $5 for all 4 + shipping from...

My 853 is a 1993 as well. S/N # ......410 I am presuming mine has the same Apitech valve. Just picked up a dozer blade (hydraulic...

Yes, they can do a lot of damage if the tapered pin come out, 15 months ago I purchased an old 763F (2,300 hours) that had been parked...