Recent content by ffpup

Appears I have a leak from behind or around the fuel shutoff solenoid or some where in that area. I haven't tore into it yet. Noticed it a few weeks back and just pulled machine in shop for service. Is the a o-ring behind solenoid that can be replaced or do I need to look else where. The...

I made mine the same way except that the wedge moves. That way when I split the wood never moves way from me. Looks nice though.

Just saw your post. Mine works well!! I can grapple with mine, dig stumps, or dig a hole. Not as good as digging with a bucket or digging stumps like my 12" bucket but works none the less.

Ok prob last post on this thread. I changed case drain filter it was not clogged and no metal. Change hub oil again and no metal flakes. This hub had been getting really hot a lot more than the other one, but after I drained it and refilled again I ran it for 3-4 hours hard and both hubs were...

I replaced one filter today and I am gonna do the other saturday. I gotta pull track to do it. I talked to dealer today he indicated they had not had good luck with replacing seals. He may have thought I meant motor seals. Are these seals one in the same or are there two sets in each side? I...

Im not real sure. Ill have to check on this. Im sure some of these professionals on here can tell me. I am able to curl bucket and release thumb at the same time, but it would be nice if this was kinda automatic. I do this when holding logs for fire wood. I curl my grapple to make a cradle to...

Ok I resolved to not leave you guys hanging when I ask of help….. so here goes! I went to the dealer today and they were gracious enough to give me a break down of the solenoid block and told me which two controlled the auxiliary functions of the thumb. For reference its the 3rd and the 4th one...

Well I guess I could….stay tuned. I gotta go play firefighter today but Ill be home tomo and will see about swapping them around. I don't see why it won't work. Thanks antfarmer2 I guess I may have thought about that but hadn't as of yet. I was looking at it yesterday and it looks as if Bobcat...

Ok folks here we go its stopped working today and besides one intermittent time it has worked for multiple tries. I managed to find out (i think) the module/solenoid block is located inside the side cover it has the bulb on it that looks like a toilet float. My question is how do I go about...

Yes I still have it. If you want to text or call me tomo Ill measure it and let you know what it measures. 336-240-5143

I was gonna try and drill the holes out too but I didn't see a way to get them close enough to use and would probably still have to add washers. If someone could measure them out and get them close and drill with maybe an 1 1/2 bit it would make a cleaner job I'm sure. It just seemed like alot...

Oh and the pin mics almost perfect to 1.250 or 1 1/4. My machine shop guy turned it out so when it shrinks from welding it will still take the pin. I got a 12" piece cause it seemed like it was a good length to have and for him to work with.

Yes I cut holes in the sides of the bucket and added washer like you said. Ill try and post some pictures in a few days. I am using the pin that is with the machine in the x-change. I used the pipe as the washers on each side. do a little measuring that I didn't do and cut holes in bucket off of...

This maybe to late for bingoo but I needed to change 3 buckets over to new pin on style. I got a piece of schedule 80 pipe and had it turned out about 15 thousands so it wasn't to tight when I welded it. I cut 1/2" pieces like thick washers. I then took a torch and cut holes in bucket at close...

Ill check that. Thanks