Recent content by farmkev

Ya sounds right, we will definitely try that bro, thanks for the response.

Topper Is yours a series 3? Mine is a 2007 pre-3 430

You are correct lol! Took out the solenoid and replaced with a short bolt, and everythings working great. Thanks for the input man. What do you know about timing? She gets to smoking, running rich it seems, after a couple hours of working. I have learned that if I run it constantly at about...

Thanks bro, will definitely be better at future greasing

Ok thats what we were thinking after swapping electrical leads with tilt solenoid and getting the same result. I want to just cap-off and toss those solenoids but was told it might throw some codes which could shut a guy down. We'll be playing with it again here in a few minutes and see what happens

I got it. Removed grease nipple which wasnt accepting grease and sprayed in some lubricant, and with a bit of persuasion got it. I never even knew there were grease nipples for those pins, lesson learned. Thanks for responding, now to get those lift arms working.

Did you have to replace or bypass solenoid? Is that lockout solenoid located under the seat? I'm about to continue the adventure lol tilt cab and make this issue go away permanently.

Hey Barry, I am experiencing the same issue, were you able to get yours resolved?

I have a similar issue with my 2007 430. Were you guys able to rectify issue, and if so, what did you do?

Trying to remove my bucket on case 430 skid steer but right hydraulic bucket pin release appears seized in the lock position. Any ideas other than use a bigger hammer on it??