Recent content by ejl

I disconnected the battery when I was doing wire checks. Approximately 2 hrs

Hello again. I did all the wiring checks and found no problems. After looking at the manual, I than tried to put the eic into diagnostics mode and it won’t go there. Is there a positive way to know if the eic is bad? Is there a way to just check the eic?

Thanks for the info

I’m going to start checking for bad wires.

I replaced the set switches after one of them tested bad. The skid steer started up and I was able to use it. The next day the issue came back.

Hello everyone. I’m new to the forum and thank you for allowing me to participate. II retired several years ago from the steel industry.

I have a new Holland lx465 skid steer. When I sit on the seat most of the lights on the eci light up. When I fasten the seat belt that light will not go off. When I turn the Key on the alarm sounds. This issue happened to me several months ago. I did nothing and the next day it was fine. I’m...