Recent content by dvalin

That's why black pipe is used for gas and I assume for hydraulics since I just repaired a John deere auger by replacing factory black pipe with black pipe from the depot

Thanks yep know about cost of handles as may have to replace right one as I am not getting reverse flow haven't done any trouble shooting yet

T300 bobcat not getting reverse flow at switch ,auger will turn one way had to swap hoses to turn it proper way to dig where should I start trouble shooting what should my voltage reading be at end of switch wires be is it the rear soloniod that controls reverse flow Thanks for any info

Yeah I Was wanting to use a switch on control handle just to keep it neat so I guess I will go with a relay Thanks for ur input

Thanks for ur response I was thinking along those lines but somebody else had mentioned relays . Just need to identify wires powering the control head and run them to the battery I would assume Bob cat switches can handle 10 amps to 20 amps if not no big deal if I burn them out not being used...

Have a T 300 attachment has 2 pins single soloniod

What size relays would u be using

This sounds like what I want to do did u leave the wire harness connected or did u disconnect just leaving 2 pin counter to supply power to the switches

12 not 22

Why are the relays neccessary couldn't it just be wired as a 12 volt switch not totally familiar with 22 volt systems

Look forward to learning about skid steers and doing my own work

I would like more info on ur device and possibly purchase trying to marry a timberline treeshear to Bob cat and need to purchase something