Recent content by DPReef

Follow-up. So I replaced the charge filter which was really dark, didn't see any metal shavings, flushed hydraulics from the fan to reservoir with new fluid, cleaned the fan and added some silicon grease where the shaft meets the motor. Fan starts moving on start-up and spins much faster than...

See if it’s getting voltage to the solenoid, I had a recent issue and replaced my filters and it started working

when i spin the fan, it's definitely not "loose" but I will take a look if there is any chance the shaft is spinning and the fan is not. When I spin by hand, there’s definitely a fricton of some sort like a motor/gearbox am sure it’s not free spinning.

No machine codes. So i went out there and turned the engine on, used a wrench to spin the blades (not with my fingers) and it started going! Drove it around the lot and the fan did spin faster. Shut off the engine, restarted still "stuck". Once I give the blade a little movement the...

I went and checked all the fuses, and none were bad (check for continuity only right?). Below is a picture of the fan motor, that #1 is just the charge line.. The motor housing has two electrical connectors. I guess one is for the solenoid #23 and the other is the sensor #27? Do I just check...

Bought a used Bobcat Skidsteer T650, was driving around to do some grading on my property and it overheats right when I hit a load of dirt. The hydraulic cooling/blower fan doesn't turn on! Sprayed it with a pressure washer and cleaned out dirt that was below the radiator. I can spin the fan...