Recent content by das220

Thanks for the help Tazza. Your the best!!!

Tazza I can see why you should pull the pump that is under the seat, but do not under stand why you should pull the motor? I am a real green horn at this, this is my first bobcat. Is the chain sprocket on the rear shaft that far back in the chain case. the manual say's that the sprocket can be...

Need some advise please. I just found that the right rear axel seal is leaking on my 632 skid loader. i was thinking that a might try and replace the seal my self. is this a bigger job then it looks. I have never had the chain case open before what needs to be removed to get acces to the rear...

Hi guys! thanks for the input on this problem! but i sure am dumfounded as to why my arms are so much lower then normal. If there is no adjustment for the stop then what has changed? I thought there might of been an adjustment on the cylinder or something. Do you think that the pins on the arms...

I have an old 632 that is still running good. but just notest that when i let the arms all the way down with the bucket flat on the ground that the hydrilic line running on the under side of the lift arm is hitting on the flange that runs over the top of the tires. is there an adjustment that...

Dase I just finished changing the right rear on my 632! I used a 2x12 blank and then but may jack on that make sure to spray some deep creep on the rusty bolts before you start they rust up in a big way. I would also but a jack stand under it, just in-case the hydralic jack leaks off. best of...

Hi skiddy thanks for the input on this. IF any one cares I got it all but back together tonight. man this machine is not easy for just one guy to work on, bolt on the out side of machine nuts on the inside what a tough time trying to get lock-washers & nuts on without the bolts falling out but...

that makes sense I will try and jake it back up and then re-bolt it, to the old marks the best I can it should be a little easy'er with the tire off. I can't tell if there are lock washers on the other nuts should i use lock washers and do you know what they should be torgue too. thanks again!

m610 thanks for the reply And thanks for the input! I got the tire of this morning after soaking with deep creep. sorry just an average Joe with not much for tools. had to do lug nuts with a 1/2: drive and pipe. Yes i have the Ford engine i see the distributor but not sure where the vacuum hose...

was using my machine for about an hour today running just fine, when i got a flat on the right rear tire. I got out to look at the tire with the machine running the engine backfired. I jumped back in and shut it off, trying to figure out what had happened. looked over the engine and at looked to...

Thank you for the support. I have only had this machine for a month, but it has been just fine so far and i have a hole list small jobs for it. is there a site on the web that i might down load some instruction for changing the bins. or should i spend the time and money to try and find a...

I have bought my first used bobcat (632) and have two question if someone can help that would be great! i would like too change the pivot pins at the bottom of the bucket? is this a big job,can i do it myself? i do not have any matinance manuals for this machine. I have the ford gas engine in...