Recent content by dancat825

The first photo is definitely one of the shafts that will disengage the drive gear. Undo the retaining nut and pull the shaft out about 4 inches. Right side is near the rear axle and left side is near the forward axle.

I had a similar issue on my 1982 Bobcat 825 and ended up replacing the Cessna hydraulic motor with a "good used" that was sourced for me by a company called ConEquip. Very helpful...give them a call.

Hi Mr.C, I have a new-to-me 825 that needs the Bobtach lever/pin kits for left and right. Did you ever find a compatible model that uses the same lever/pin kit ? Thanks

I'm in Canada but I assume that is $US. It's good to know that there are options available out there. Thanks.

Welcome...I'm new to the forum as well and have found some helpful information int the chats.

I have a "good used" motor on the way but I would like to hear about your options. 71402 DAG and 6R 23 LD are stamped on the housing as shown in the attached pics. My parts manual shows the P/N 6519643 for DAG style motor or P/N 6669566 for upgraded DBA style motor. Case dealer cannot get...

Hi Everyone, I'm the new owner of an old Bobcat 825 skid steer that needs a new hydraulic drive motor. My local dealer was not helpful and I'm not having much luck finding a used or rebuilt drive motor on-line. Can anyone tell me if there is an equivalent hydraulic motor that can be used...

Did you find a compatible alternative?

I just picked up an old 825 that needs a new hydrostatic drive motor. Did you ever find a compatible motor to replace yours? Mine is an old style motor stamped 71402 DAG but my service manual says that these were upgraded with motors coded DBA. Wondering if the new DBA is a direct swap...any...

Hi there, I just bought an 825 yesterday and I'm new to the forum. The price was right because it needs a new right side drive motor. I'm told that these are hard to find. I just ordered a service manual for it. Can you recommend a part source where I can get a rebuild kit, refurbished pump...