Recent content by Cyclone Ranger

Can someone help me find the documentation needed to adjust the steering linkages on an MT52? Thanks in advance.

Does anyone have pictures of their fuel delivery system on a 632, 642, 732, 742 they would like to share? I'm in the process of converting to an electric fuel pump and would be interested in seeing how others have chose to mount the pump as well as locate filters, shut-off valves, hard and soft...

I'm looking for a door for a 742 (round lights). Most of the doors I see have flat fronts and have the handle on the right but I have seen a few doors with a dip along the bottom edge and the handle on the left. Does anyone know if both of these door styles will fit a 742 or how to visually...

For those of you replacing the mechanical pumps on your gas engines I'd recommend adding an oil pressure switch to shut the pump off when the engine is not running. One scenario in which this could be important is in a rollover. In this scenario, the engine dies, the carb needle is open and the...

With winter around the corner it was time for some new traction tape. I found this for $12 and free shipping. It did the trick. http://thelongboardstore.com/grip-tape/mob/black-11-grip-tape-4-sheet-1/

U-joints are available here: www.drivetrainamerica.com Neapco 1-2186, $48.09 Neapco 1-2185, $40.84

On my Fords, the distributor is held in the block with one bolt and another tightens a ring around the shaft to prevent it from rotating. Make sure both bolts are snug. Regarding your timing, check that the vacuum advance is working. Either with a hand vacuum pump or your mouth, confirm that...

Anyone find any good sales out there? My 742 needs a new pair of wheel chains and a starter.

Does anyone here happen to have a spare two groove crank pulley for a Ford industrial 98CI engine?

Thank you!

I have a Ford powered 742 with a stock Mando alternator which has S and EXC terminals that connect to a red and a purple wire. Does anyone here know which color connects to which terminal? Thanks.

That's the one. The black cap sitting on that ocean of blue goodness.

Which grips did you end up going with? How do they look?

Very nice! The breather I'm referring to is behind the fuel pump. It sits on top of a baffled container that mounts to the side of the block. The breather itself is about the size of a white mushroom.

I'm looking for a replacement crankcase breather for a Ford 1.6L. It uses a 3/4” push in style breather. I've found a few automotive options but none that fit the limited space available for this motor. This part is no longer available through Bobcat. If you know where to find one please let...