Recent content by Curtiss

Help Support SkidSteer Forum:

  1. C

    L170 no lights on EIC

    hello Mike I have 12v at pin4 J2 when in the seat. also 12v at pin11 with seat belt connected. there is a toggle switch upper left under a cover. with the switch in position A the 12 v is not present on pin 4. with the switch in position B the 12v is at pin 4. the skid steer will crank over in...
  2. C

    L170 no lights on EIC

    not sure if it is a L or LS yet. the EIC has a J1 connector also 11 pins. will check pin4 and pin 11 on J2 next.
  3. C

    L170 no lights on EIC

    Hi Mike10, i do have 12v to the seat and belt. also, the EIC board does have 12 v on pin14 of th J2 header. in addition the warning buzzer is activated when the key is on.
  4. C

    L170 no lights on EIC

    Skidsteer runs, looks like no power to the EIC. nothing lights up on the EIC. can not lift or rotate bucket. i know the seat and belt switchs are ok. the EIC module itself looks clean, no burnt out parts. what is the method to check for proper power and signal to the EIC?
See more
Top