Recent content by cnv65stang

Hope this helps... if not message me back... maybe we can find it.

Follow the wires coming from the fuel shutoff solenoid. .. on my f series 763 there is a pigtail between the main wiring harness and the solenoid. As i understand it, that is the timer. There is a waterproof cap inline, remove it and there is a 25 amp car type flat fuse in it. Something else is...

I figured out the solenoid not holding... it was a burned fuse inside the timer relay.... feel stupid for not finding it right off the bat... THANKS TO EVERYONE FOR ALL THE HELP! I am still chasing the slow draw on the battery though... can't seem to find it..

I went out to test yesterday evening and the battery is completely dead. It is a new battery from about 2 weeks ago. I am getting a draw on it somewhere too....

When I checked the pigtail going to the solenoid, i didnt get anything on the draw side... is that the timer or ?

Thanks.... i need all the help i can get. :-)

Thanks. I will try it out tomorrow when Im back at the farm.

That makes sense, can you walk me through how to test for the three scenarios you listed? Wiring is NOT my strong suit... lol.. Thanks!

I have searched everywhere and can't find a problem like mine... i am sure I am just missing it, but anyway... I have a 1997 bobcat 763 f series. The fuel shut off solenoid will not engage when the key is turned. If I turn the key to ACC then walk behind and push the solenoid over to the run...

I tried it out again today. Seems like the thumb switch is sticking. .. could that cause it if the thumb switch is sticking in the on position?

I was using the thumb switch... been hectic with my mom being sick and I havent had time to try it back out... any suggestions would b great! Thx

Thx. I will give it a shot and let u know. I appreciate it!

It hasnt been used much at all in a really long time. I operated the grapple for a little bit and open and closed it a good number of times. Just switching the aux hyd button on and off depending on if i wanted to operate the grapple or the lift and tilt. I am not sure how to tell if it is on...

What am i supposed to jiggle?

No. When the aux hyd button is pushed, the grapple opens and vloses perfectly.... the lift and tilt doesnt.