Recent content by chardway

Gadget 264 - thanks for you post. I checked the eBay clutch you referenced and it may in fact work so I am going to watch it. Both of my electric clutches have failed so I removed the inner one (high speed) and had the outer one (low speed) welded solid so that the pulley turns all the time...

I took the v-belt drive system apart yesterday. There are 2 pulleys mounted on the engine shaft both of which are actuated by integral electric clutches. The outer clutch/pulley is the low speed driver and the inner clutch/pulley is the high speed driver. Both of my clutches are "bad". The inner...

Shane - Thanks again for your help. Any idea where I could buy a used crankshaft clutch assembly for a 310?

"Thetool" - Thanks for the information. So if I understand you correctly, any time the engine crankshaft is turning (i.e., motor is running) the v-belts should be turning. Correct? This is not the case right now so I assume my clutch must be bad. Is this difficult to remove? I also assume that...

Brand new to this forum. I just bought a Bobcat 310 skid loader to mess around my house with. It needed a head gasket which I replaced and the engine now runs good. However, I am having problems with its moving and turning. I noticed that when running, none of the pump pulleys are rotating...