bugleboy62's latest activity

This is the pump that I use on my 37hp Yanmar (sailboat) and on my 743. Facet FEP304SV Posi-Flo 12 volt Fuel Pump Kit, 1/8 NPT Ports, 1...

Success! PB Blaster applied liberally over two days and an 8' cheater bar did the trick!

I'd take a maul and just give the lever a good smack, their pretty tough.

My thoughts exactly. I'll definitely try all that before I start banging away at the stuck pin.

normally one can manipulate things by lifting the bucket and using tilt to adjust things the top of the quick attach does NOT always...

Note the gap where the bucket is not fully seated

I've been soaking in PB Blaster to see if I can get it loose. I think the stuck pin is bound because the opposite side is not fully...

Your pin looks dry. Dump some motor oil (new or used) on the pin and let is soak a bit. It shouldn't be too difficult to remove...

One more thing on this, If that hose is long enough to cut the end off and reuse it that may save some $$ but if not make sure you match...

You can very carefully raise the bucket and use a hammer to punch the pin up from the bottom.

I screwed up trying to release my bucket and now one pin is stuck and the other pin is free but the bucket is not fully seated in the...

Thank you.....will do asap.

As they all said above. If it is possible to replace it do it. This hose is most likey a steel braded hose and will go at some point...