Recent content by brapp

no this machine doesnt have the boot and slaver cylinder for brakes. it has the internal brake washer/ disk that releases with hyd pressure but that was all rebuilt and rolls freely when the brake is released. it literaly feels liek the pump is cavitated or the pump is not gettign any fluid at...

i have called everywhere i could find and noone has anythign that new. i gues smy only option unless someone can point me to a kubota yard or something that will interchange is a new one from kubota for 5400 bucks.

lookign for new or used eiter way but i dont have 5400 dollars for the entire assemby new from kubota.

ok her eis what hgappened i am lookign for the entire drive motor and planitry assembely for a 2003 kx91-3 the housing on mine broke a huge piece out of the side of it does anyone know a good place for fairly new equipment parts besides a dealer?

wanted a front hydro pump for a deere 250 and i need a bunch of other parts also let me know what you have.

once i get it back inside i am goign to buy guages and fittings and run pressure test on it and see if ther eis anything that is restricting it or if there is debris blockign flow to that pump. i could really use a diagram of the pump itself and how the hydro fluid flows trough them so i can...

well i have a pair of s185's and a deere332 rented this week and have all 3 of my employees runnign them and once i get everythign cought back up i plan on pulling the deere250 into the basement of the house and havign a clead dust and dirt free enviroment to tear it apart and do it right. i...

the brake seal on the putside went bad and dumped hydro oil into the chaincase. so i pulled the entire assembely and took it to a retired heavy equipment mechanic i know and now dont have anything from the pump once re installed.

well if thats the case and it cost me 5 k to get the pump figured out i will part it out before then. that 2.9 turbo diesel would make a heck of a wood splitter lol but i will try and see what i can do to rebuild it .

i will check for plugs and i will see what i can do here this afternoon, i am workign in the home office today so i will have a hr or 2 to look it over with a clear mind . if i decide to just have the pumps rebuilt and start over with a clean fresh slate possibly rebuild other drive motor and...

what i do not know and cant comprehend is how does the fluid get from the charge pump to the problem pump?? is it internal ports or is it a external line that i am overlooking. i have literaly spent hours apon hours reading up on the hydrolic system on this machine. and i do have flow out the...

well i know somethign i never knew before. and if the pump was going bad wouldnt it still make some pressure and spin the wheels with them off the ground and no resistance on them?? i am not gettign anything and whine or anything from the pump.

it really does seem liek its not doign anythign but moving the linkage and i dont thign the swash plate is moving, and alotther thign is i think there mat have been soemthign in the hyd resivor also , i was usign coffee filters and had one come apart to strain the hyd fluid for reuse. i am just...

i have also run about 15 galons of oil trough the lines trying to purge air from the system also. i dont have acess toguages to get pressur ereading i do knwo the charge pump is pushing a little over 60 psi but what it seems liek its buildign pressur ebut its not lettign pressure go to the...

ok well here is what i had found out, i have charge pressure trough both pumps, and it ran perfectly fine before the teardown of the drive motor, it as just a brake seal that went bad. but the pump sat dry for a few months while tryign to order parts. and i have tried cracking line after line...