Recent content by bode

SHould of said if run hard it will shut down. From the guage it has gradual charge pressure loss at idle no use.

Ok, pulled the sender and installed a guage t'd in. Pressures on cold start up are 300 roughly, at low idle the gauge goes down to around 250-270psi after 10-15minutes and it kicks the light on. Its a 2000psi guage so these are within 20psi probably. Left side case drain line has heat in it and...

Will do. Anyone have a outlet for a good manual. All i need is the diagnostics chapter. My book doesnt give troubleshooting on anything and is a bobcat manual.

Got the seal kit installed and drivemotors looked through. Bobcats seal kit had wrong brake piston seal in it so had to wait a few days on it. Anyways machine runs great and hydraulic r nice and quiet...but still have that darn low charge pressure light on. U guys have any suggestions on how to...

Pulled the right side drive motor that was replaced by bobcat...the hydraulic shop found a seal that separates the brake portion of the drive was shot...more than likely letting charge pressure leak by thus the low charge. Hopefully this is it and the saga is over.

Would also like to ask how one can tell of drive belt is slipping? Belt looks to be in good shape and don't see and rubber or burnt smell from a slipping belt? I

Yes the entire pump assembly was gone thru from gear pump to input shaft. I am not sure what the symptoms were when my brother dropped it off. I know they put a 2sp right side drive motor in it. Fresh fluid, new filter and case drain filter installed also when I r/r the assembly. Bucket controls...

We spent over $500 at kc bobcat getting it diagnosed. That is where they wanted to start. I am a decent mechanic and can turn wrenches so we pulled it to save a few thousand dollars...it's more than a electrical/sensors problem b/c the steering sticks start getting stiff if we keep running it...

Ok, here is where we r at. Installed rebuilt hydro unit. Heritor pump plus gear pump etc...still have the hydraulic oil light come on?

Guys, hydraulic pump guy got back with me...pump does have wear 1/1000th. He said other parts are worn but nothing spectacular given age/wear. Recommended rebuild and new relief valves, new suction hose, and clean the tank. BUT, he doesnt think its all the problem. He is leaning towards a drive...

When u say charge pump, the one hanging off the rt side of unit or the internal? Also, the spacer your referring to is on the right side of the unit correct? Gettting a quote on the rebuild next tue/wed. so fingers are crossed its in decent shape and just needs a internal pump.

Well not the first time we did someting the hard way. lol. Do you know if I can put a pulley that is a little bit smaller or bigger in the hydro unit and run correctly? I broke ours pulling it and only used one I can find are 8.5" or 8.75" and ours seems to measure 8 5/8"...I would think smaller...

Looking for a dbl pulley on our 863 that runs the fan and hydro unit from the main drive belt. Anyone have available? I think there r tow sizes and from what I gather it's the larger one around 8.75" diameter.

What is best hydraulic fluid to use in this machine? Right now we r using a napa brand AW**, forgot the viscosity.

So u can pull the engine and hydro quicker than pulling hydro unit out the front? We left the puller on the pulley over night and next morning I tightened it as much as I could and smacked again with hammer and she popped off. Wont get a quote for repair for another week. Prob should of got a...