Recent content by bobcatgrant

Is there supposed to be coolant visible in the radiator when cold when you remove the cap? I have coolant in the recovery tank at the minimum level but was wondering if I should be seeing coolant in the radiator when I open the cap when it’s cold? This might sound dumb, but it doesn’t say...

I use to own one. It had split shaft. I would assume it’s for ease of changing belt

I would like to install an aftermarket heater in my 2002 753g series. Ive seen the posts on the web how easy it is and blah blah blah. My question to you Bobcat guys is where do i hook this thing up? I see the Bobocat has an adapter plate that mounts under the thermostat housing. Is that...

same here with a m600. It called for atf because of the clutches. And actually toward the end of my ownership of it , we were using utf with no real signifigant change in operation. guys at the hydro shop said it would be cheaper to run that and there was no real difference in utf when it came...

Hmmm, interesting. I have not alot of knowledge on certain hydraulic operation but i thought thats what the case drain is for , direct line back to tank with no ability to reverse flow

I was thinking along those lines but the plow manifold has ability for flow thru according to BOSS plow mfg. It has coils for the valves and when you press the switch it energizes the specific coil for cylinder operation and again for release so I'm not sure that's the problem. Boss recommended...

Originally i had it that way but the cylinders wouldnt retract fully and very slow(single acting with spring return tightened to the max) Still had same issue of no ability to have boom or tilt function when aux hydro were engaged. SEemd like pump labored more that way also. which is why i...

yes the actual case drain in the middle of the aux block. The female on the aux block i have going to pump port on the plows manifold and the tank port going to the case drain.

Hello, I have a 2002 753g. My question to all you out there is I currently modified a BOSS v Plow(late 80's version) to attach to my skid steer. Got the hydraulics to work thru my auxilary on the front by plumbing thru female connector and case drain into the original manifold. Works well or so...

anyone??? curious as i want to plumb boss v plow direct from my aux hyd and just add 2 valves to control the v. Not a hyd expert by any means so what kid of valves would i need ? open center closed center . the cylinders are single acting

curious on how you did the spool valve ? i have an old boss plow and want to run it through my aux hydraulics. i have a 753g....

Still was getting the code after i turn the aux hyd on after a short while. I have a western plow attached to the aux for blade angle. After awhile the blade will start moving itself without touching thumb(for/rev) button on the rh stick. So I took it apart and it was a little dusty but not bad...

2002 753g 3400 hrs -oops sorry about that

Hi , I'm getting the 12-22 code, and not as frequent the 12-23. Is this telling me the paddle switch on the right stick is going bad? If so, tips on how to replace if needed. Also ive noticed this winter now that after a wet snow or operating in wet snow that the next day i go to use it , I have...

Me dumb. So the i figured it out i think. So Im looking at the drive belt and its only got 2 grooves. It should be 3 right? outside groove was seperated from other 2 Which is why I thought it was another belt. It flipped off/broke and knocked the fan belt off.