Recent content by bluffcam

the test light does show power to selonoid with a test light when key turned to on. when my buddy turns the key to on I don't hear anything back at the pump. Its a bear to get to the selonoid so I'm trying to be pretty sure before i try to get the selonoid out to check it, there is a little...

Need a little more help getting this machine going. The machine ran out of fuel and checked the book and bled the fitting near dual filters and one on the injection pump. no go changed fuel filters and filled filter with fuel bled again no go tried some starter fluid and would run for a...

Thats good info, now i have to figure out how to wire it and what type of selonoid to use. Is this what would be required? http://www.maliburacing.com/starter_solenoid.html thanks

This has been a problem with my 1845c since i got it at auction 2 years ago. I have tried the usual fixes increasing in cost as the fix does not solve the problem. first cleaned, wire brushed terminals and nuts on starter and battery and reattached. then replaced battery then replaced starter...

Any tips on repairing crack in rear pivot of lift arm. I was considering pulling pin and lifting up 6 inches or so and grinding a v in each side and weld crack. wondering if this cracking is common and if there is a better way. thanks heres a picture(worth at least 100 words)...

Its a long story but i am helping out a friend who has had a tough time. She has what is called a trackmaster 85 made by LMC corp., it has a Kubota V3300 and is a tracked. Uses it to plow a long driveway. The machine has two very similiar tanks on each side of the machine, one is diesel fuel...

It is the gizmo(servo) with the two small hydraulic hoses. I got a feeling this setup didn't work out too great as the manual has about 5 changes in this steering depending on serial number. There is a large bushing and bolt that bolts to pintle on hydrostatic pump. then there is two 1/4“...

well this 843 with an isuzu has been an interesting project. Supposed to be an easy u-joint repair. The machine was run with the u-joint failing for as long as possible i figure. The rear engine mounts vibrated a square groove 1/4” deep in frame, the wobbling u-joint broke hydro pump shaft...