Recent content by Billwoodm3

I'm not sure if it's potted or not but it has a bad seat bat sensor to ground code and 8 volt ref out of range. Checked every wire again. Twice. Still cannot get seat light to stop blinking 3 times and other 4 lights to go out. Where does the 8 volt ref come from because on my power probe it...

I'm not sure if it's potted or not but it has a bad seat bat sensor to ground code and 8 volt ref out of range. Checked every wire again. Twice. Still cannot get seat light to stop blinking 3 times and other 4 lights to go out.

This is such an old post don't think I will get a reply but I have the same exact machine with the identical problem and same exact codes all to the t. Did you ever figure what the problem was and if so what was the solution. Any help would be great. Thanks Bill

I've traced all wires for shorts crimps or breaks. None found. Originally thought that was causing the short for all the sensor lights to be on at start locking bics systems

Yes it's a g series with triangle lights. And the lights are on the right panel. The only light that's on on the left panel is the blinking lapbar light.

I have a 02 753 bobcat and right from start I get 5 lights. Hydrolic oil temp-hydrolic oil pressure- oil pressure and coolant temp. Also lapbar light blinks and beeps three times. The bics system has controls locked. I replaced seat bar sensor and magnet. Did oil change including all fuel,oil...

I have a 2002 Bobcat 753G, and seem to be having a problem with the seat bar circuitry. The Bobcat will start up and run, but will not move. When I turn the ignition key to the RUN position, the seat bar light/LED on the BICS instrument panel (left side), starts flashing continuously in a series...