Recent content by BigJohn

I thought for sure it may be a grounding problem because this happened before similar. But I ran an external ground and nothing happened. I went on youtube and found out how to check relays. There are four relays to the heater but all are good. I decided to take of the main fuse panel and there...

I've checked all the fuses and they're good. I just got to figure out how to check a five pole relay. There's four relay to the heater blower. I just don't understand why my lights won't work either unless there tied into the same power system. I'll keep plugging at it, thanks Tazz

Has anyone had a problem like this before on there skidsteer. I checked all the fuses and wiring. Everything seem to be ok. This happened to me a few months ago and the only thing that I did was recharge the battery the next day and everything worked. Not this time. Machine runs great, all the...

Thanks Tazza, I'll give that a go and see how things work out. Thanks

The engine has been removed and totally rebuilt. Now for some reason the machine travels faster in reverse then forward. Would there be something that was done wrong or needs adjusting? Needs help from you experts, thanks.

your right Tazza. I took the switch off and you see a clear blubble on the top. I pushed on it a couple a times and banged it around on the bench, Installed it again and ran the machine for awhile and no more light. The switch still works because the continuity test showed ok. Thanks, Tazza

When I disconnected the ( Air Temp Sensor ) the light still stayed on but when I disconnected the( Pressure Swith ) the light went off.

That indicator light is known as ( Engine Air Filter Restriction Indicator)

I have a 318D with 400hrs on machine. When I was operating today on a very rainy day and My air flow indicator in the cab came on. I shut the machine down and replaced both filters (primary and Seconday ). I went back to operate again and the indicator light came back on again. On that system it...

What does the conversion kit consist off and where would you get such a kit?

I finally got the machine running smooth and a big thanks to all your guys for your suggestions. When I bought this machine they told me they had installed a new timing belt but they only adjusted it and didn't replace it. It had jumped about four teeth, I'm surprised it had started at all...

I'm sure it has something to do with fuel pressure. I'm checking the timing belt and also the injectors and see what happens after that. Thanks for getting back to me.

No, the aux hyd isn't stuck

Thanks

How do you determine the Top Dead Center of a Peugeot engine on a bobcat skidsteer?