Recent content by anitel

Help Support SkidSteer Forum:

  1. A

    What type and make of hyd oil should I be using?

    I use hydraulic fluid called R & O from autozone. This is a good general purpose hyd fluid and doesn't break the bank on cost. I'm of the belief that it is more important for the fluid clean than expensive. Also when you drain the hyd fluid remove the small hose going into the bottom of the hyd...
  2. A

    still looking for answers/ help with my Bobcat

    Check the solenoids with a continuity meter. solenoids are located at the top of the hydraulic control valve under the driver seat. If it is not that then you may have an electrical short somewhere between the hand control and solenoid. Check the service manual for wiring diagrams and info on...
  3. A

    Remove engine on a 763?

    It's really quite easy to pull these sideways mounted engines. Just disconnect the hose and steering linkages going into the main pump under the cab. You will need two large wrenches and lots of patience to do this but it is the best way. When you put the hoses back on later use new O-rings from...
  4. A

    steering problem

    Do yourself a favor and buy the service manual from a dealership near you. It's the best ~$60 you will spend on the machine. Another thing you might try to removing the chain case access plate that is directly between your feet and running under the front edge of the seat. You should see lots of...
  5. A

    looking for skidsteer salvage/used parts

    I've got access to pretty much every used part you might need. What are you looking for? Thomas Eastham www.goskidsteer.com 713-851-9693 [email protected]
Top