Recent content by 7LBSSMALLIE

7lbssmallie, hey dudes, checking in, all good 63, retired; kinda miss being on the front line though, that is until i started reading new posts on stuff like , code whatever, you now have half power until code cleared,

anyone ever ever heard of tip and tell? a device used on packages to see if they have ever been turned over, think hour glass. v shaped, works on equipment too

there are steps to take after a rollover.

it seems that a post of how to handle, flipped equipment. might be needed, as well as attention to entire hyd sys after a failure. it aint me dude,

rods will be bent.

was case drain filter not replaced? two units both with drive motor replacement. major hyd failure soon after? where did the metal go?

case drain filter already exits on unit (keep in mind im old) , have to remove floor board,? been abit, why not just look up parts break down,

743b overheat.. boss or non boss, acutal or indicated, 2203 i assume, common casuses cracked head back left hand corner. t/s check for prenseces of combistion gassaes in radiator, positeve test you got your answer, where id start, napa stuipd tool suck the gasssas thru thru fluid if it changes...

if youre smart enough to have a laser thermo, you got this nailed,

if youre smart enough to have a laser thermo, you got this nailed,

the early 853 aux hyds, were an add on., it had four relays, located on leftjust below the stick , d

you should not be able to turn motor by hand, i mean if you want to roll it thru takes a pretty substantive

maybe? replace the lift arms. used might come with piping and tilt cyl

hint if can can run non ethanol gas do so, will extend eng life

check for cracks around bolt holes as well. drill a hole, at stopping point, grind and weld.