Recent content by 123ruger

did not move very much at all never went below 90lbs i guess i will pull trans. pump out this week thats all that is left the guy that rebuilt it said he has never had a bad one i guess i got the first bad one. out of things to check

put gauge on it it read 90lbs 95 at full thottle what is the pressure suppose to be ? thanks

the pump under the square block i know it works the lift can it have anything to with it not wanting to turn left or right if it was weak?

ii ran it up on blocks about 30 min. with clear tube running to resavior very few bubbles still no left or right it growles and trys but wont turn could it be that new pump? new pump new filters new fluid new seal kits in drive motors what else is there

they were out of time got it going tbut still no left or right thanks for your help

were is the charge pressure sending unit? is it in front of the square block thanks for your help

i run it for a few minutes how long does it take. will i need to bleed it?or will it bleed its self i can not figure this one out. could it be that new pump?

had pump rebuilt checked filters resealed both drive motors new fluid i jacked it up and it would turn left or right but on the ground would not turn left or right makes a growling noise please help i am going crazy

would this affect that it will not turn left or right if motors are out of time only go foward and back

the local hyd shop put the seal kits in them i asked about the timming he said it was right maybe i got sum hoses cross how would i get a map of the hoses or a manual local bobcat dealer is no help

put a rebuilt pump on new seal kit in drive motors new bronze filter it goes foward and back but they work backwards and it will not turn left or right it is driving me crazy. does it make a differance witch side the motors go on is there a left and a right motor