Hello to all and thanks in advance! I have been reading and learning – but my first po st. First of all the machine is 200 miles away and trying to gain information from family members via the phone. Here is what I know so far. Machine is a 773 G with about 2000 hours on it, it has the digital display with the keyless start etc . Symptoms started several months ago with the machine not wanting to move (Release the brake) unless the RPMS were up , if the RPMs were dropped the brake would engage. This would continue until the machine warmed up then it would operate normally. This continued for a while but sounds like it slowly degraded to the point the machine would not move at all. Dealer said it was the RPM sensor on the flywheel; this was replaced with the machine not moving at all now. Other known items Loader portion works fine Three of four green lights are on with the one not lit – they think brake release light is not on. Digital tac was all over the place, now no reading at all – blank I asked if they could hear the brake solenoid activating – answer was unknown – may have answers tonight Also asked if the machine would move at all – 1-2 inches – again answer unknown Wondering your thoughts Thanks – Chris