Hey Guys
This was a recent purchase for us and when we first got it it would blow white smoke and after about a minute it would stop blowing smoke and run fine.I replaced all 3 Glow Plugs because I thought the white smoke was from unburned fuel.When i was in there i replaced all 3 injectors...
Hey Tazza, You were right on the money !! When I checked power behind the fuse box I wasn't getting a light on 1 post even though the fuse was good.Clamped a jumper on it and I heard the failure BEEP as I had the key on the On position.Working 100% Now.Thanks Again!
Hi Tazza, I have removed the complete dash panel and i have no power to any of the wiring harnesses. I will check to see if I have power coming in and out from behind the fuse panel. Thanks
Hey Guys I have an early 2000 G series 763 Bobcat that never gave me any issues until now.I don't have any power to the cab.No instrument lights or power to ignition.I can jump the starter with a screwdriver and hold the fuel solenoid open and it will start and run. Here is what I have Checked...
I have a Ditch Witch 140 Backhoe that I was going to mount on a 763 Bobcat.I saw Junkman's photos and that is a nice rig! Could I mount it to the Bob tach instead.I have a make up plate that I was going to bolt to it. Thanks 412 292 5183
Hey Bernie I just purchased a Ditch Witch Backhoe Attachment at an auction.I want to attach it to my 763 Bobcat. Do you have any information and photos of yours? Thanks
Hey Guys I have a 2001 model 763 Bobcat and I have a chance to purchase an older Bradco attachment that I was told was not Hi Flo.Would I be able to use this on my Bobcat if it is not Hi Flo Thanks
I have a 5575 that leaks Hydraulic fluid from the bottom of the machine.I took the seat off and tried to locate the leak by operating the lift arms but I still cant locate the leak.Is there a recurring problem with the 5575.Possibly like a hose from the hyd.tank that might wear from movement.It...
Purchased this machine in non running condition because someone ran it out of oil.From the info that i have, the engine would be a 3032C Perkins Diesel.I dont want to rebuild it or pay 6K for a rebuilt one.
Hey Guys I have a mid 80's Model 642 Bobcat that had a blown Mitsubishi Gas Engine in it.I replaced it with a Kubota 3 Cyl. Diesel .The engine is installed and "piped in" but I am in need of a wiring diagram for this Kubota D1005 Engine.Or just some basic information to get it fired.Also are...
Thanks for your reply Tazza.I got the cylinder out by putting a hydraulic duckbill under the lift arms and sliding the cyl. foward as you suggested.I may now have created a bigger problem.I put the cylinder in a vice and tried to get the end cap off with a pipe wrench and a punch and hammer.No...
I need to replace the seals in the lift cylinder on a 741.I was able to unbolt and remove the pins on the lift cyl. but now i cant get it out of the machine.I cant get it out of the rear of the machine and i cant slide it out of the front of the machine because the boom is in the lowered...