Recent content by mattyc5094

http://i246.photobucket.com/albums/gg81/mattyc5094/DSCF1237.jpg http://i246.photobucket.com/albums/gg81/mattyc5094/DSCF1236.jpg http://i246.photobucket.com/albums/gg81/mattyc5094/0907091100.jpg

Thanks Tazza, I will call them. Was the 743b gear pump more volume than my 743 vane? I think the Main pump it bolts up to is the same

Has anyone tried to install an early 843 pump onto a 743 to get more gpm? will it work? I am looking to run a 5 ft hrush hog and the gpm is just under the requirements that all these attachments require. does anyone know of a way to get to 15 gpm on my machine without adding a belt driven pump...

Mike, Thanks for the Bucket! your bucket is better quality and built than any I've looked at and cheaper than most people wanted for a beat up bucket.Well worth the drive, keep up the good work......................

Driving up from Florida on the 26th of Feb. do you have have any 60" low pro's in stock

AXLE BEARINGS TIMKEN – LM104949, TIMKEN – LM104912, SEAL NATIONAL - 40301S

Just took my 743 apart last week. take the drive motor off, prop the wrench on the nut then drill 2 holes in a thick piece of 5' steel to fit over 2 wheel studs. use the leverage! or buy a 1 1/8" combo wrench then torch the open end off and stick a pipe over it. I thinek its all the same as my...

looking for a back-up bucket for my bobcat 743 machine.

Thanks! I had a hard time finding the seals online... cost $66 for 4 of them shipped. bearings were dirt cheap @ www.rockauto.com they were $6.87 for cup and $7.81 for the cone each. thats only about $170 to do all the bearings and seals. all new chains cost me another $190 for heavy duty 80h...

******BOBCAT 743 KUBOTA V1702******* FILTERS OIL FRAM - PH16,PH43 HASTINGS - LF196 AIR INSIDE FRAM - CA255754 HASTINGS-AF631 AIR OUTSIDE FRAM-CAK253 HASTINGS - AF129K HYDRAULIC FRAM -P6884, HASTINGS -HF719, BALDWIN – BT8861 DRIVE CHAINS #80H DIAMOND 14,500 (2-10' lengths will do all chains)...

does anyone have bearing number for the axle bearing and races on a 743 bobcat. would like to purchase from a bearing supplier i believe the seal # is 40301S national seal

I removed the bearings from my old reduction gear box on my 743 and came up with these cross reference numbers: (SKF bearings and seal) BR3720, LM501310 (2), LM501349 (2), JLM506810, JLM 506849, seal CR 25713. all these parts came to $80 shipped. I did some google searching and came up with a...