Recent content by kyosho

Thanks Machinist. I clearly have an older model that should have had the support located in the door. The door has holes in it - but no brackets and no support. The newer style support I have that I got used is like the one in the picture above. My lift arm does not have the rod at the front nor...

[email protected] - I wish i knew how to edit an existing post...

Hi Bill B - I dont know how to post them either to be honest. Can you email it to me at [email protected]? Thanks!

Oh wow. I thought it was the type that was mounted right up by the cylinder on the lift arm itself. No idea it was mounted on the back door like that. Thank you for the picture! The support I have is the new style - the style that DOES mount on the lift arm - since the part number was replaced...

Can anyone please tell me how part #: 6705089 LIFT ARM STOP Was 6700615 is mounted on the lift arm? I was able to find a used part of it but can't figure out how it mounts on the lift arm. The hydraulic lines are on the bottom of the lift arm and it tucks against those but I don't see what holds...

kubota 15521-65512 ngk y106v http://www.ebay.com/itm/15261-65513-New-Kubota-Set-of-Three-3-Glow-Plugs-B5100DP-B5100EP-B6100DP-/261313703672?pt=BI_Heavy_Equipment_Parts&hash=item3cd782aef8#ht_335wt_867

I would also add there mine DOES have some small springs on bushings between the bar and the an oddly shaped spacer. I just looked at the parts online and it appears all the parts are there. Does it need to be tightened or something?

1987 bobcat 743. The seat bar - the safety bar you swing down in front of you - on mine it wont stay in the up position. Are there springs or something on it that might be missing? What is it that is supposed to keep it in the up position? I have mine held with a bungee cord right now. Thanks!

Great. Thanks! I'll give them each a call and see if I can find one.

According to the dealer it is part number: 6705089. If anyone can point towards one I would appreciate it. thanks!

I need the lift arm stop for my bobcat 743. The red steel bar that you insert to hold the lift arms up to safely work under the lift arms without danger of them collapsing. Can anyone point me to a good place to get one? I searched the internet and ebay etc. and could find one. Thanks!

Thanks for the help guys. Last night I got it started and I used it this morning as well. Somehow the fuel lines got air in them - from not using it? I don't know. I removed the bolt from the top of the fuel filter housing and squeezed the primer until steady fuel came out (all over the inside...

Ok so you are trying to isolate if the pickup from the tank is clogged or not. Got it. Nothing personal but I don't post where I live - had a strange thing happen from it once. Not on this site. ;) Has nothing to do with you but with people searching the internet, etc.

Ok. So upper right side of engine bay - look for the sight glass. Be careful it's glass. Got it. I've had the machine for 4 years and have used it alot. What would cause this all the sudden? The cold? On the top of the metal that the sight glass screws into - there is a wheel you are saying? So...

The injector pump block is to the left. The line comes from it, goes up, over to the right, then down into the head. That is where I disconnected it. While cranking, how much fuel should come out of that line?