Recent content by Joefire

Hello all, I am looking for some Timing tools for the injection pump on this LS190 skidsteer...Had injection pump rebuilt and It just does not seem to be set correctly...Rebuilder stated he set timing to 5 degrees when my manual states it should be 29..When I installed the locked pump I noticed...

Thanks Tazza, It does not have a mechanical lever for fuel shut off. I suspect that what they call an enrichment system may be the fuel cut solenoid. You can ohm any solenoid and should be under 30 ohms,but that is just one test.. Going to look on internet for more info.. Thanks Joe

Hello and Happy Holidays to all.. I have some questions about this machine. It cranks over fine but does not start, I have approx. 8psi fuel pressure from electric lift pump and volume appears to be good.I do not have repair manual for this machine to check specs,etc. Sometimes I will get fuel...

Thanks for your responses , I have not had chance to recheck machine yet ..I need to recheck track tension this week, so as soon as I get it back in shop I will update.The tracks are O.E.M. Bridgestones

I dont have the engine size yet but it is a KIA engine. The problem is the machine was overheated. The engine hydro locked and when they tried to restart, it snapped the starter drive shaft. I replaced the starter and was able to get started but exhast pushing coolant out.and engine missing. I...

I am working on this skidsteer and I would like to know if anyone knows where I can find engine repair info. IE, cylinder headbolt torque etc. Thankyou ,Joe

The reman. pump cost 1300 plus 300 core charge . new is over 2000 . Its a great idea to disassemble pump to determine what happend , you could have other problems that caused failure. In my case the bearing or what was left of it didnt show any signs of oil starvation etc. I decided to go with...

hello all, I have an update on my problem. My service manual has the test procedures so I was going to test drainback on the motors but the lines in the man. do not match my set up . i then decided to swap the hoses from the left pump,you have to move some things but its not impossible.The R/s...

Thankyou for the info. I will check it out. Joe

Hello all, I have a few 4 / 1 buckets I need parts for . Piston seal kits, bucket pins etc. Can anyone recommend where I can locate parts. Thanks , JOE

Hello all, I have some tech. questions in testing the pumps on this unit. Unit has boom, bucket power, L/s drive works but seems sluggish, R/s drive inop. I first tested hydro. charge pressure spec. calls for250-300psi under full throttle, I have 210. I found wire in harness for pressure switch...