Recent content by jeepcreepcj

Did you find these? I might have motor mount plates if you are still looking for some.

“whistlindiesel” makes videos on YouTube, he is very successful at it, so it seems to be a principal thing as well as a source of content for him. He definitely can and would pay the reward.

Thanks tazza, located near grand rapids michigan.

I have engine parts for a 4g32 bobcat 642b I would like to sell. I bought this as a basket case, with a spun rod bearing. I started to rebuild this engine, and ended up swapping the machine to a kubota diesel. I believe I have everything besides the governor. I do not have any non engine related...

Thanks for the reply SR, that appears to be what happened. I pulled the spool out and managed to get the cap off, the detent ball had some rust and pitting, which when in the right position caused it to jam. I will be checking to see if I can buy just the small springs and bb'sfrom the dealer...

After using my log splitter for a few hours last weekend, the auxilary hydraulic valve has become stuck in the on detent position. I cannot get it to release with reasonable force, and checked to be sure that nothing was blocking the linkage to the valve. I plan to pull the two screws on the...

I suppose its about time I let go of my extra gas engine parts. Send me an email with your offer [email protected]

My bobcat had the mitsubishi 4g32 engine. I do have all the engine parts but it will not work for your ford powered 642. When I had trouble locating a blower wheel I ended up finding a good used one from hess brothers in indiana, they just shipped it to me. I have bought other parts from them...

Here is the best pic i have, the right cooler line is painted white and makes a u shape. http://i657.photobucket.com/albums/uu300/jeepcreepcj/DSCN2400.jpg

I put a kubota d1105 in my 642b. Many of the kubota engines had mechanical lift pumps or the option for one. Mine has the option of a mechanical pump but did not come with one. There is a spot below the injection pump where it mounts. If your fuel line goes directly to the injection pump, you...

The engine is coupled to the pump with splines on the yoke, it will just slide apart once everything else is undone. So the g32 had a casting in the block for the starter to mount to? If I remember correctly, the starter in the bobcat is positioned and attached by the motor mount plate where a...

What was different between the two that would not work? They were both 4g32 engines, correct?

I first tried finding a car motor as a replacement for my 642b. I was unsuccessful in finding one as they are so old, no junkyards have them anymore. I would suspect that they would be similar as far as mounting holes in the bellhousing area and manifolds. I think the car motor may have had a...

Did you get this going yet? I am interested to know if the eclipse crank worked. Please let everyone know!

The serial number tag is above the radiator, on the left side. It should be easy to spot when standing behind the machine. I got my manual on ebay. It is possible someone on here has a pdf manual but I couldn't find anything less than ebay. I didn't check with a bobcat dealer, as I heard manuals...