Latest activity

I know the engine is different,I have a onan ccka 14 hp 2 cylinder opposed engine on a welder, and the magento went bad and is n.l.a...

.016" is @ the peak of the POINTS CAM lobe. That should be at or near TDC if I'm reading correctly(?) The gap will remain the same...

That’s what I’ve been hearing. I plan to go and take a look at it with a jump pack and a can of starter fluid to see if I can get it to...

I'll betcha it turns out to be the fuel pickup. Given it was running and then quit and won't restart (though it turns over), occam's...

I'm running a Bobcat S650 that I picked up used about a year ago, and I've been slowly building out my attachment lineup as jobs come...

I had a carb on a Bobcat 742B tat leaked gas into the oil pan. Since the fuel tank was higher than the carb the fuel just kept flowing...

OK, Ive read that points should be in the fully open position ( assuming TDC ) so if that is correct then I am good to go.... I hope.

Rankin Oakes A-L Parts Inc./ Thomas Equipment Office Line 506-278-3715

So I dove into italthough I was hesitant to do so. Pulled the radiator and muscled the front cover as much as I could, found the timing...

a few things is, in order to access the front cover The radiator needs removed, the points are on a base with a plunger so you dont see...

Per AI Timing an Onan NHC 25-horsepower, 2-cylinder engine requires setting the breaker points precisely at 0.016 inches and statically...

Per AI Timing an Onan NHC 25-horsepower, 2-cylinder engine requires setting the breaker points precisely at 0.016 inches and statically...

When I had my T-133, I used to get parts from AL Parts in NB Canada. But after the company restarted production, parts were only...

Well got it opened up and as suspected number 4 exhaust valve was in the open position and appears water found its way in. Now the...

Question on rotating this motor, I cant find any access to rotate this motor and to find TDC so I can adjust and set the points if...