Reply to thread

Message: <blockquote data-quote="Cooee" data-source="post: 115963" data-attributes="member: 10607"><p>hey there Maddy Are the shafts on top of the transmission pumps fully actuating ...I had a similar situation where the servo rams that turn the pintel shaft on the pump wern't fully extending One of them was bypassing in one direction That caused the shaft not to turn in one direction and hence a similar scenario ... Think I disconnected the servo rams jacked machine off ground and used a big shifter to rotate the pintel arms ....That at least / first told me wether the pump was delivering oil ...My machine sounds to be similar in the pump drive configuration though I'm not sure what actuates the pintel shafts on OMC441 ....If its mechanicaly operated IE : levers and rods you may need to check that the lug mounted to the pintel shaft isn't loose and rotating without actually turning the pump shaft .....when i first got my machine the lugs had been let go loose and flogged the keyway in the shaft I repaired it with that Devcon liquid metal and have had no trouble 15 yrs now ....Hoping its something simple usually is Cheers</p></blockquote><p></p>