Reply to thread

Message: <blockquote data-quote="wizard" data-source="post: 3815" data-attributes="member: 185">I ended up removing the pump again after lossing all power in my steering, so I could do an insp. on the pump. I found the replenishin valves had some minor wear, so I was going to replace them but at 260.+ for the forward and 45.+ for the reverse you could say I reversed my mind. Is it common for this valves to go bad, and is there someplace where I could purchase them at a lower cost.What happened is the BC just creeps with no power in both directions, and steering in either direction the pump just squeals for mercy. On the vane pump it says to check for wear on the vanes and the block section. what is normal wear or abnormal wear on the block.</blockquote>