Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
TILT CYLINDER
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="wizard" data-source="post: 3350" data-attributes="member: 185"><p>When I resealed it the first time, I installed new seals on all 3 cylinders ie: tilt, lift.</p><p>This last time I resealed all the tilt section, spool & what I think were the load checks or what I called load valves.</p><p>I'll go through my manual to verify, and I'll let you know. Before I resealed the 1st time it had an external leak at the tilt cyl., it fixed the problem. this 2nd time I was moving some old bricks that were all scattered. After about an hour the bucket just would not stay up.</p><p>That's why I changed the seals on the tilt section, but the results.Thanks again TAZZA, like I said I'll have to verify if I resealed the correct parts.</p></blockquote><p></p>
[QUOTE="wizard, post: 3350, member: 185"] When I resealed it the first time, I installed new seals on all 3 cylinders ie: tilt, lift. This last time I resealed all the tilt section, spool & what I think were the load checks or what I called load valves. I'll go through my manual to verify, and I'll let you know. Before I resealed the 1st time it had an external leak at the tilt cyl., it fixed the problem. this 2nd time I was moving some old bricks that were all scattered. After about an hour the bucket just would not stay up. That's why I changed the seals on the tilt section, but the results.Thanks again TAZZA, like I said I'll have to verify if I resealed the correct parts. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
TILT CYLINDER
Top