Reply to thread

Message: <blockquote data-quote="hvyduty" data-source="post: 7395" data-attributes="member: 823"><p>sorry the format changed on the last one making it hard to read.this is the basics behind the code. A Code 14-03 occurs when the Bobcat Controller does not detect a voltage on the feedback wire 8150 from the Fuel Shutoff relay when commanded. The Fuel Shutoff solenoid is energized by a pull and a hold circuit. The pull coil, wire 8100, will be energized with a high current from the Fuel Pull relay when the Bobcat Controller detects that the engine start has been activated. Possible cause: Fuel Shutoff relay. Fuel Shutoff solenoid. Fuse 6. Ground wire 2040. Wire 1310 to the mega fuse. Wire 8100 shorted to ground. Wire 8110 or 8150 shorted to ground or open. Bobcat Controller. Moisture, corrosion, or pushed back pins in the Mainframe harness. If the code is intermittent and not on at the time of testing, the cause of the code may not be found at this time. Probable causes may include: loose connections, corrosion, pushed back pins, the controller, the wire harness or a combination of these problems I got all this info when a 863 i was working on was playing up it ended up being the solinoid.</p></blockquote><p></p>