Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
The Mitsubishi 4G32 and you. A comprehensive guide to surviving poor financial decisions and overhauling a terrible engine.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Dave1234" data-source="post: 134029" data-attributes="member: 23099"><p>I'm pretty sure mine is OEM. Also 2 piece axles. The end that connects to the float is like your original one. I didn't have any shims in mine. It seemed to be running rich, so I bent the float tab a little, eyeballing the float to sit more or less level when held upside down and in place, although it was pretty close to begin with. But I would like to be able to do better and know I had it right. I also didn't get what I would call proper adjustment out of the idle mixture needle--it didn't seem to make much difference, which along with smelling rich was what got me into the carb. I didn't find anything there to fix other than a minor change in float level. I also couldn't find any info on the off-idle adjusting screw that is part of the idle circuit.</p></blockquote><p></p>
[QUOTE="Dave1234, post: 134029, member: 23099"] I'm pretty sure mine is OEM. Also 2 piece axles. The end that connects to the float is like your original one. I didn't have any shims in mine. It seemed to be running rich, so I bent the float tab a little, eyeballing the float to sit more or less level when held upside down and in place, although it was pretty close to begin with. But I would like to be able to do better and know I had it right. I also didn't get what I would call proper adjustment out of the idle mixture needle--it didn't seem to make much difference, which along with smelling rich was what got me into the carb. I didn't find anything there to fix other than a minor change in float level. I also couldn't find any info on the off-idle adjusting screw that is part of the idle circuit. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
The Mitsubishi 4G32 and you. A comprehensive guide to surviving poor financial decisions and overhauling a terrible engine.
Top