Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Other Brand Skidsteer Forums
ASV / Terex Skidsteer Forum
temporarily looses drive power
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="roblarss" data-source="post: 86721" data-attributes="member: 9491"><p>I got the pump back and i'm not to worried about most of it. The 2 axial piston pumps look fine to me, no scoring. Both the end bearings are bad. One has lots of friction to rotate and one has a little play. They look standard are cheap to get. The gerotor pump looks terrible. The rotor it self has only very fine, barely can feel it marks. The wearing side of the pump is the casing and has deep wearing, im suprised there is no wear plate. Can the cast steel, im assuming it is, casing be welded up and milled down or is this not worth it. Its close to $3000 for a replacement pump. Im close to just ordering a new pump.</p></blockquote><p></p>
[QUOTE="roblarss, post: 86721, member: 9491"] I got the pump back and i'm not to worried about most of it. The 2 axial piston pumps look fine to me, no scoring. Both the end bearings are bad. One has lots of friction to rotate and one has a little play. They look standard are cheap to get. The gerotor pump looks terrible. The rotor it self has only very fine, barely can feel it marks. The wearing side of the pump is the casing and has deep wearing, im suprised there is no wear plate. Can the cast steel, im assuming it is, casing be welded up and milled down or is this not worth it. Its close to $3000 for a replacement pump. Im close to just ordering a new pump. [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
ASV / Terex Skidsteer Forum
temporarily looses drive power
Top
