Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
T190 starts and runs fine for 15 seconds then shuts down with code 5-15 but test gauge shows 300-350 psi charge pressure
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="pcmachine" data-source="post: 138697" data-attributes="member: 25789"><p>I'd like to verify the hydraulic pressure signal is getting to ECU/controller. Can anyone help me with the connector/pin number on the ECU that carries this signal from the pressure sender on the filter block?</p></blockquote><p></p>
[QUOTE="pcmachine, post: 138697, member: 25789"] I'd like to verify the hydraulic pressure signal is getting to ECU/controller. Can anyone help me with the connector/pin number on the ECU that carries this signal from the pressure sender on the filter block? [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
T190 starts and runs fine for 15 seconds then shuts down with code 5-15 but test gauge shows 300-350 psi charge pressure
Top
