Reply to thread

Message: <blockquote data-quote="thedassler" data-source="post: 101526" data-attributes="member: 15657"><p>Hi BC873G, Thanks for confirming the voltage reading!! Although it seems like it will be a game of "twister" trying to calibrate on the machine, I think it is sound advice and it will take a lot of guessing out of the total situation. I will start off tomorrow by re-assembling the two actuators and then set them back in the machine and calibrate for 1.72 while in the machine. Any thoughts about my motor comment? As I said, I am not sure about the motor in the newest actuator, but as it is literally if not technically functioning, I am all for giving it a try...just thought you might have some additional thoughts. And yes my connector has 5 wires 2 for +-12v to the motor and 3 for POT in the actuator (2 for the 5V and 1 for feedback). Thanks again!!!</p></blockquote><p></p>