Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Stumped 773f
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="mrWhipper" data-source="post: 126381" data-attributes="member: 23146"><p>I have a 773F. It is throwing a code HF 1-6 on BOSS. (Manual says this code means the hydrostatic charge filter sensor has no signal). The bics is flashing 3 times on the valve light. I have replaced the valve stem and the magnetic coil solenoid. I also tested all wires to make sure I had continuity and all passed. I then thought it was the bics unit, but I hot wired around that to no avail. It seems that if start it and hit the pedals right away, the lift/tilt works more often. If I wait, it does not work at all. When it does work the hydraulics stay working until I turn it off. Any thoughts on what to do to solve intermittent tilt/lift not working? Would the charge filter sensor cause the lift/tilt not to work? </p><p></p><p>Any guidance would be sincerely appreciated.</p></blockquote><p></p>
[QUOTE="mrWhipper, post: 126381, member: 23146"] I have a 773F. It is throwing a code HF 1-6 on BOSS. (Manual says this code means the hydrostatic charge filter sensor has no signal). The bics is flashing 3 times on the valve light. I have replaced the valve stem and the magnetic coil solenoid. I also tested all wires to make sure I had continuity and all passed. I then thought it was the bics unit, but I hot wired around that to no avail. It seems that if start it and hit the pedals right away, the lift/tilt works more often. If I wait, it does not work at all. When it does work the hydraulics stay working until I turn it off. Any thoughts on what to do to solve intermittent tilt/lift not working? Would the charge filter sensor cause the lift/tilt not to work? Any guidance would be sincerely appreciated. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Stumped 773f
Top