Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S250 electrical issues
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="brdgbldr" data-source="post: 120969" data-attributes="member: 7474"><p>I'm no expert but here is what I would try.</p><p></p><p>First of all replace or swap the starter relay with another just to see if it will start or not, just to eliminate a bad relay.</p><p></p><p>Check all of your fuses. I'm not familiar with S250 but I believe it has a 100 amp megafuse behind the battery and the wires come loose causing low voltage. I know I've seen a few posts and this was the cause of many problems. I know this sounds silly but you'd be amazed at what a bad fuse will do. Also remove and clean the battery terminals and connections if you haven't yet.</p><p></p><p>With all of the codes being sensors in different areas it sounds like the controller is having problems. This could be a bad controller, but I think that maybe you have a short in your wiring or low voltage getting to the controller. Look at any areas of the wiring with sharp bends or where the wire harness may have rubbed through.</p></blockquote><p></p>
[QUOTE="brdgbldr, post: 120969, member: 7474"] I’m no expert but here is what I would try. First of all replace or swap the starter relay with another just to see if it will start or not, just to eliminate a bad relay. Check all of your fuses. I’m not familiar with S250 but I believe it has a 100 amp megafuse behind the battery and the wires come loose causing low voltage. I know I’ve seen a few posts and this was the cause of many problems. I know this sounds silly but you‘d be amazed at what a bad fuse will do. Also remove and clean the battery terminals and connections if you haven’t yet. With all of the codes being sensors in different areas it sounds like the controller is having problems. This could be a bad controller, but I think that maybe you have a short in your wiring or low voltage getting to the controller. Look at any areas of the wiring with sharp bends or where the wire harness may have rubbed through. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S250 electrical issues
Top