Reply to thread

Message: <blockquote data-quote="mrbb" data-source="post: 129317" data-attributes="member: 13825">I could be wrong,. but doesn't that whole screen panel come off with a few bolts?? why not just un bolt it, rather than ruining it by cutting a section out of it??(on my NH they all are set up this way, , its also has to be removed to clean window, which is a pain, but its not that  bad a deal I'd want to ruin them by cutting them up) if its welded on in any place, just grind the welds off, so it can be removed, I cannot see them being needed for structure support IF set on cutting, I gather a grinding wheel in an angle grinder would work,(be even easier to do if you remove to cut , but sure it can be done in place on machine just be harder to smooth edges afterwards if left on to cut) but I wouldn;t ruin  then if they can be taken off,  but your machine your call!</blockquote>