Reply to thread

Message: <blockquote data-quote="Chalmers" data-source="post: 106224" data-attributes="member: 15979"><p>Parts info: DRAWTITE 41991-16 is the complete assy. THE SIDE PLATES alone FOR DRAWTITE 41991-16 ARE Drawtite # 4196 SOLD SEPARATELY ON ETRAILER FOR $81/PAIR Be careful - the cross tube is only 60" wide.You may need to sleeve it/weld it if your machine is wider. Dimensions of holes in the Drawtite side plate are here: https://www.etrailer.com/Accessories-Parts/Draw-Tite/4916.html. Use some of these holes to mount the side plate in the empty counterwieght holes predrilled at the factory.Mark for new holes to be drilled. You need to have at least 5 bolts per plate to achieve sufficient(??) load capacity YEMV Just mount the plates horizontally(not as vertical drop plates like in a Service truck application) - pointing toward the rear of the Bobcat. Extend these side plates if necessary to clear the closed door.. Remove the drawbar when not in use or you want to open the engine access door.Use tractor hitch pins for this. I hope this helps.</p></blockquote><p></p>