Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
ASV / Terex Skidsteer Forum
PT100G joysticks non responsive
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="martinoamy" data-source="post: 120962" data-attributes="member: 22065"><p>You might look at Can bus resistors (terminators).</p><p></p><p>On the display ohms between Pins three and four that's the yellow and black wire I believe should read 60 ohms. If the ohms are 120 then one of the can bus terminator resistors on either end is no good. There is one behind the display panel . Looks like a connector that terminated right there. Mine has 3 red dots. Open it up and check resistance between the pins in the cap. Mine also had a sticker that said can bus 0. </p><p></p><p>The other end is below the controllers below the Batteries . There should be an 1.5" x 6"</p><p>Plate there but mine is gone and there there are two more terminators. 0 & 1. Check those.</p><p></p><p>Check those both of my lower ones read 0L. Meaning an 'open'.</p><p></p><p>2 resistors in parallel will read 1/2 the resistance of the parallelled resistors</p></blockquote><p></p>
[QUOTE="martinoamy, post: 120962, member: 22065"] You might look at Can bus resistors (terminators). On the display ohms between Pins three and four that’s the yellow and black wire I believe should read 60 ohms. If the ohms are 120 then one of the can bus terminator resistors on either end is no good. There is one behind the display panel . Looks like a connector that terminated right there. Mine has 3 red dots. Open it up and check resistance between the pins in the cap. Mine also had a sticker that said can bus 0. The other end is below the controllers below the Batteries . There should be an 1.5” x 6” Plate there but mine is gone and there there are two more terminators. 0 & 1. Check those. Check those both of my lower ones read 0L. Meaning an ‘open’. 2 resistors in parallel will read 1/2 the resistance of the parallelled resistors [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
ASV / Terex Skidsteer Forum
PT100G joysticks non responsive
Top