Reply to thread

Message: <blockquote data-quote="willett" data-source="post: 114303" data-attributes="member: 18283"><p>Got quad rings from a hydro shop for the whopping price of .87 each. For future reference if anybody reads this thread the vickers pump inlet seal dimensions are: 1.75 OD, 1" ID and .300" thick. Pump is a vickers ta1919v10r I used a $20 2 jaw puller to get the splines off the shaft. I also pulled apart the detents for aux and boom float. The old grease hardened up and the detent balls wouldn't fall into the groove on account of the hard grease. Its a real bastard to get the socket back over the balls so I cut a 1/8" notch in 1 side of the socket at the leading edge. Now the socket slips over the one of the balls and the other ball goes into the notch. I used a screwdriver to compress the ball in the notch and then pushed the socket over. Kind of difficult to explain. Hope I'm making sense. Spent an hour screwing around trying to get the balls in. Took 30 seconds with the notch cut.</p></blockquote><p></p>