Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
No start 743b
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="oiu789" data-source="post: 130057" data-attributes="member: 15807"><p>Disconnect the jumpers between the glow plugs, set multi meter to the lowest ohm setting, touch one lead to ground and touch other to top of glow plug should see around .8 ohms on each you could check what a new one ohms to compare. This way you do not need to remove the plugs unless they show bad. Does the primer bulb get firm after squeezing and not go soft right away it should stay firm for awhile this indicates that air is not getting back in.</p></blockquote><p></p>
[QUOTE="oiu789, post: 130057, member: 15807"] Disconnect the jumpers between the glow plugs, set multi meter to the lowest ohm setting, touch one lead to ground and touch other to top of glow plug should see around .8 ohms on each you could check what a new one ohms to compare. This way you do not need to remove the plugs unless they show bad. Does the primer bulb get firm after squeezing and not go soft right away it should stay firm for awhile this indicates that air is not getting back in. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
No start 743b
Top