Reply to thread

Message: <blockquote data-quote="tony_d" data-source="post: 55882" data-attributes="member: 7547"><p>My New Holland LS180 shuts down after 30 seconds. You get the alarm code for the hydrostatic fluid blinking and the yellow stop light. Everything seems to be functioning fine. I replaced the charge pressure switch recommended by the dealer. I also replaced the hydraulic oil filter. Basically when cold the machine runs fine. It will run fine until you shut it down. Once you shut it down and try starting up again you will get the fault and it will shut down. There is no loss of power to both bucket and drive system. Any thoughts would be much appreciated. Other info -20 hours on new engine oil and filter -.5 hours on hydraulic filter -Topped off hydraulic oil - 10W30 -Replaced Switch Pressure sensor - 86534287 - Tested old sensor with air compressor and ohm meeter and it was working. - Tested new sensor with engine on in diagnostic mode sensor reads correct ohms under pressure I also disconnected the hydro filter green wire to test, then I put it back and now I get the hydro temp alert. The temp is more then fine, operating at 120-130F. It's supposed to only go off at 230F. Tony</p></blockquote><p></p>