Reply to thread

Message: <blockquote data-quote="Jeffscarstrucks" data-source="post: 19761" data-attributes="member: 1245"><p>Hi, It has the two large high flow couplers on the lift arm and the smaller in and out for standard flow on the right side operator console, at your right knee. these machines also had a 3-point hook up as an option and you could reverse the drivers position for use as an ag tarctor (popular in vinyards) so I think that is the reason for the hyd configuration. The standard outlets are variable flow both directions with float also so it will do fine (I think) on a normall Bobcat attachment. I am trying to figure a good way to configure the hoses, Make up hard lines on the arm or use flex from the existing outlets. The High flow is controlled from a seperate valve and is just in or out; or it runs the 540 PTO in the other end of its travel. Thanks for replying and I look forward to reading your other posts when I have a chance to spend some time on the computer. JEFF</p></blockquote><p></p>