Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
making a post hole digger
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="case310350" data-source="post: 7563" data-attributes="member: 655"><p>whats the typical rpm of a post hole digger? I made one years ago out of the street cleaner brush motor direct drive, rpm's maybe 120. ths was a small motor but had plenty of torque, used a 9 inch auger. will hook up the bigger motor and check the rpm. since this was the drive wheel (tire mounted directly to the motor) of a three wheel street cleaner it may allready have bearings.</p></blockquote><p></p>
[QUOTE="case310350, post: 7563, member: 655"] whats the typical rpm of a post hole digger? I made one years ago out of the street cleaner brush motor direct drive, rpm's maybe 120. ths was a small motor but had plenty of torque, used a 9 inch auger. will hook up the bigger motor and check the rpm. since this was the drive wheel (tire mounted directly to the motor) of a three wheel street cleaner it may allready have bearings. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
making a post hole digger
Top