Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
M-700 carb question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="6brnorma" data-source="post: 96095" data-attributes="member: 5914"><p>My opinion……I deal with this engine a lot. I think it is one of two things…….I do not think it needs a pressure regulator. The carb calls for 2 to 3 PSI…..you say you have put an electric fuel pump on which I believe is the only route to go, however, not all electric fuel pumps are created equal. The only pump I will use(and I have used several) is the NAPA pt#P60504 (which if I recall correctly is a Carter with the same part number)……..or………like Tazza has said, probably float issue. You said you used the "recommended" setting……I have seen a couple of different "recommended" settings depending on the kit. I always go with the 1 5/32 setting on all of my rebuilds and never have a problem. Hope this helps.</p></blockquote><p></p>
[QUOTE="6brnorma, post: 96095, member: 5914"] My opinion……I deal with this engine a lot. I think it is one of two things…….I do not think it needs a pressure regulator. The carb calls for 2 to 3 PSI…..you say you have put an electric fuel pump on which I believe is the only route to go, however, not all electric fuel pumps are created equal. The only pump I will use(and I have used several) is the NAPA pt#P60504 (which if I recall correctly is a Carter with the same part number)……..or………like Tazza has said, probably float issue. You said you used the "recommended" setting……I have seen a couple of different "recommended" settings depending on the kit. I always go with the 1 5/32 setting on all of my rebuilds and never have a problem. Hope this helps. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
M-700 carb question
Top